Jump to content

Ncichit

Members
  • Content Count

    3
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral

Personal Information

  • First and Last Name
    Walter Blohm

About Your Machine

  • Which type of machine do you own?
    650 or 1050 Autodrive (all types)

Stay Informed

  • Keep me updated about the following product(s)
    PrimerSense
    Primer Orientation Sensor
    Primer Check
    BulletSense
    On Board Primer Collator
    DecapSense
    PowderSense
    Powder Check
    Conversion Kit
    Mark 7 Training
    Mark 7 Trimmer Kit
    Programmable Powder Measure
    Mark 7 Accessories
    Bullets and Brass
    Lee Precision Dies

The recent visitors block is disabled and is not being shown to other users.

Enable
  1. Using Mark 7 650 Pro with XL750. CCI 450 Primers are protruding from the bottom of the case and not seating far enough when attempting to reload .223 cases. Primer Depth/Bottom Trim setting is 0. I am performing a calibration with a clear shell plate. The ram upstroke appears to be ok with full upstroke, however, the downstroke i am unsure of, as the bottom of the knuckle does not enter the cut out in the bottom of the frame (see calibration photo). I am using a new motor purchased from Mark 7 two days ago. Anyone had any luck with this?
  2. Ncichit

    General Operation

    I too am having the same exact problem. Using Mark 7 650 Pro with XL750. CCI 450 Primers are protruding from the bottom of the case and not seating far enough when attempting .223. Primer Depth/Bottom Trim setting is 0. Anyone had any luck with this?
×