Jump to content

Recommended Posts

On 5/20/2019 at 5:31 PM, Mark7-Calvin said:

Adjusting Primer depth on the Mark 7® 650 Pro Autodrive

Adjusting Primer depth on the Mark 7® 650 Pro Autodrive.pdf

Do You have a special procedure for Dillon 750? With dial to 0 I am not getting a proper primer setting and it protrudes too much. Calibration procedure done with no shell as usual. I passed from Dillon 650 used for the last 3 years to the new 750 and now i am having this problem. Thanks

Share this post


Link to post
Share on other sites

@raffaello55, did you ever find a solution with your 750?  I too was not getting a deep enough seating and ended up placing mini circle paper wedges under the primer pin (down the hole in the slide) which lifted the pin.  I still don’t get any use out of the bottom trim function as my goal is to seat below flush.  I am hoping there is a better solution than my jury-rigged version.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×